TDS560USB Real-Time Emulator
The TDS560USB Real-Time Emulator is a new generation of emulator for real-time debugging. It not only supports high speed real-time data exchange (HS-RTDX), but can help you decrease your project time. The emulator itself is a USB device that is fully plug and play compatible and supports high speed code download. The TDS560USB Real-Time Emulator is designed to operate with TI Code Composer Studio IDE debug tool and is compatible with Windows 98SE / 2000 / XP.
High speed real-time data exchange (HS-RTDX) bandwidth over 2Mb/s, real-time event sequence server without stopping the application. Increases code download speed up to 8x faster than XDS510. USB compatible, simple connection, fully Plug-and-Play, no jumpers, no switch settings.
Real-time data exchange (RTDX) bandwidth over 2Mb/s and real-time event sequence server without stopping the application Increases code download speed up to 8x faster than XDS510 USB compatible, simple connection, fully Plug-and-Play, no jumpers, no switch settings Hot pluggable Supports multiprocessor debugging of same or different type Programmable TCK: 500KHz to 35MHz Compatible with XDS510 Overall cable/pod length of 6ft (1.5m) Hardware detection of power losses and cable disconnections Wide dynamic operating voltage: 1.0 to 5.0 volts All pod signals are ESD protected Supports Texas Instruments (TI) DSP with a JTAG (IEEE 1149.1) interface: C2000, F2400, C27X, F28X, C54X, C55X, C6000, C64X, TMS470 (ARM) and OMAP platforms Supports Texas Instruments Code Composer Studio
Code Composer Studio IDE 2.0 or greater A free USB port ( USB2.0 is recommended) 500MHz or higher Pentium-compatible CPU (900MHz or higher Pentium III CPU or equivalent is recommended) Local CD-ROM drive
TDS560USB Real-Time Emulator and Pod USB interface cable Five Volt DC power supply AC power cord The TDS560USB driver disk TDS560SB Real-Time Emulator Installation Guide Reference Guide